Asko Rangehood Filter Clip
We keep getting asked about this one — the rangehood filter clip is one of those Asko parts that fails long before the rest of the unit is done. We've made this style of part before and can usually print yours without drama.
We keep getting asked about this one — the rangehood filter clip is one of those Asko parts that fails long before the rest of the unit is done. We've made this style of part before and can usually print yours without drama.
Why these break
Filter clips fatigue and the mesh filter drops out. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Asko |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Filter clips fatigue and the mesh filter drops out |
| Typical use case | Direct replacement for the original rangehood filter clip on the Asko. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $14 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
