Nissan Navara D22 Interior Mirror Trim Cap
The Nissan Navara D22 is a car worth keeping right, and a broken interior mirror trim cap shouldn't be the thing that lets the interior down. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $22
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
The Nissan Navara D22 is a car worth keeping right, and a broken interior mirror trim cap shouldn't be the thing that lets the interior down. We've made this style of part before and can usually print yours without drama.
Why these break
Mirror stem trim cap cracks or goes missing. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Nissan |
|---|---|
| Model | Navara D22 |
| Year range | 1997–2015 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Mirror stem trim cap cracks or goes missing |
| Typical use case | Direct replacement for the original interior mirror trim cap on the Nissan Navara D22. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $22 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | Depends |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
