Husqvarna Mower Wheel Hub Cap
Husqvarna made solid gear, but the small plastics are always the first to go — and the mower wheel hub cap is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Husqvarna made solid gear, but the small plastics are always the first to go — and the mower wheel hub cap is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Hub caps crack and wheels loosen on the axle. Vibration fatigue does the damage: thousands of kilometres of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Husqvarna |
|---|---|
| Vehicle / equipment type | Lawn mower |
| Common failure mode | Hub caps crack and wheels loosen on the axle |
| Typical use case | Direct replacement for the original mower wheel hub cap on the Husqvarna. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
