Honda Hand Guard Mount
Honda made solid gear, but the small plastics are always the first to go — and the hand guard mount is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 1–3 hours
- Final pricing is confirmed by quote.
Honda made solid gear, but the small plastics are always the first to go — and the hand guard mount is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Guard mounts snap in offs and against scrub. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Honda |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Guard mounts snap in offs and against scrub |
| Typical use case | Direct replacement for the original hand guard mount on the Honda. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 5+ years under load |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
