Yamaha Mudguard Extension
Spares support for older Yamaha products is patchy at best. Reproducing the mudguard extension locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–3 hours
- Final pricing is confirmed by quote.
Spares support for older Yamaha products is patchy at best. Reproducing the mudguard extension locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Extensions crack or were never fitted from factory. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Yamaha |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Extensions crack or were never fitted from factory |
| Typical use case | Direct replacement for the original mudguard extension on the Yamaha. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | TPU |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–3 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
