Kawasaki Side Cover Grommet Mount
Salt, sun and vibration are brutal on Kawasaki plastics, and the side cover grommet mount usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
Salt, sun and vibration are brutal on Kawasaki plastics, and the side cover grommet mount usually gives up first. A tougher printed replacement breaks that cycle. With your sample on the bench this is a realistic reproduction job.
Why these break
Side cover pegs snap off leaving the cover loose. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Kawasaki |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Side cover pegs snap off leaving the cover loose |
| Typical use case | Direct replacement for the original side cover grommet mount on the Kawasaki. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 5+ years in normal use |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
