BMW Motorrad Side Cover Grommet Mount
BMW Motorrad made solid gear, but the small plastics are always the first to go — and the side cover grommet mount is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
BMW Motorrad made solid gear, but the small plastics are always the first to go — and the side cover grommet mount is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Side cover pegs snap off leaving the cover loose. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | BMW Motorrad |
|---|---|
| Vehicle / equipment type | Motorcycle |
| Common failure mode | Side cover pegs snap off leaving the cover loose |
| Typical use case | Direct replacement for the original side cover grommet mount on the BMW Motorrad. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
