Quintrex Gauge Bezel
Spares support for older Quintrex products is patchy at best. Reproducing the gauge bezel locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Spares support for older Quintrex products is patchy at best. Reproducing the gauge bezel locally is often quicker and cheaper than the hunt for old stock. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Gauge bezels crack and fog lets moisture in. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Quintrex |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Gauge bezels crack and fog lets moisture in |
| Typical use case | Direct replacement for the original gauge bezel on the Quintrex. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $32 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
