Stacer Transducer Bracket
Stacer made solid gear, but the small plastics are always the first to go — and the transducer bracket is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Stacer made solid gear, but the small plastics are always the first to go — and the transducer bracket is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Why these break
Transducer brackets snap at the transom mount. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Stacer |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Transducer brackets snap at the transom mount |
| Typical use case | Direct replacement for the original transducer bracket on the Stacer. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
