Haines Hunter Gauge Bezel
If the gauge bezel on your Haines Hunter has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $32
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
If the gauge bezel on your Haines Hunter has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Gauge bezels crack and fog lets moisture in. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Haines Hunter |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Gauge bezels crack and fog lets moisture in |
| Typical use case | Direct replacement for the original gauge bezel on the Haines Hunter. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $32 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
