Stessco Canopy Fitting
Spares support for older Stessco products is patchy at best. Reproducing the canopy fitting locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Spares support for older Stessco products is patchy at best. Reproducing the canopy fitting locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Bimini and canopy fittings snap at the knuckle. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Stessco |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Bimini and canopy fittings snap at the knuckle |
| Typical use case | Direct replacement for the original canopy fitting on the Stessco. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 5+ years |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
