Honda Marine Gauge Bezel
We keep getting asked about this one — the gauge bezel is one of those Honda Marine parts that fails long before the rest of the unit is done. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $32
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
We keep getting asked about this one — the gauge bezel is one of those Honda Marine parts that fails long before the rest of the unit is done. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Gauge bezels crack and fog lets moisture in. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Honda Marine |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Gauge bezels crack and fog lets moisture in |
| Typical use case | Direct replacement for the original gauge bezel on the Honda Marine. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $32 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
