Box Trailer Divider Pin Cap
A broken divider pin cap shouldn't sideline otherwise good Box Trailer equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $8 – $18
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
A broken divider pin cap shouldn't sideline otherwise good Box Trailer equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Why these break
Pin caps go missing and pins rattle loose. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Box Trailer |
|---|---|
| Vehicle / equipment type | Trailer / float |
| Common failure mode | Pin caps go missing and pins rattle loose |
| Typical use case | Direct replacement for the original divider pin cap on the Box Trailer. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | TPU |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 2–4 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
