Tradesman Trailer Door Latch Keeper
A broken door latch keeper shouldn't sideline otherwise good Tradesman Trailer equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
A broken door latch keeper shouldn't sideline otherwise good Tradesman Trailer equipment, and with a decent sample to work from it usually doesn't have to. With your sample on the bench this is a realistic reproduction job.
Why these break
Latch keepers wear oval and doors rattle open. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Tradesman Trailer |
|---|---|
| Vehicle / equipment type | Trailer / float |
| Common failure mode | Latch keepers wear oval and doors rattle open |
| Typical use case | Direct replacement for the original door latch keeper on the Tradesman Trailer. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | ASA |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
