Golf Caravans Table Leg Foot Cap
Spares support for older Golf Caravans products is patchy at best. Reproducing the table leg foot cap locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $5 – $12
- Estimated print time: 20–40 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
Spares support for older Golf Caravans products is patchy at best. Reproducing the table leg foot cap locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Foot caps split and scratch the floor. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Golf Caravans |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Foot caps split and scratch the floor |
| Typical use case | Direct replacement for the original table leg foot cap on the Golf Caravans. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | TPU |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 20–40 minutes |
| Estimated cost range | $5 – $12 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
