Newlands Wardrobe Door Roller
Spares support for older Newlands products is patchy at best. Reproducing the wardrobe door roller locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Spares support for older Newlands products is patchy at best. Reproducing the wardrobe door roller locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Sliding door rollers flatten and doors jam. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Newlands |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Sliding door rollers flatten and doors jam |
| Typical use case | Direct replacement for the original wardrobe door roller on the Newlands. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 5+ years in service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
