Statesman Caravans Wardrobe Door Roller
Statesman Caravans made solid gear, but the small plastics are always the first to go — and the wardrobe door roller is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $12 – $28
- Estimated print time: 1–2 hours
- Minimum order: 2
- Final pricing is confirmed by quote.
Statesman Caravans made solid gear, but the small plastics are always the first to go — and the wardrobe door roller is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Sliding door rollers flatten and doors jam. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Statesman Caravans |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Sliding door rollers flatten and doors jam |
| Typical use case | Direct replacement for the original wardrobe door roller on the Statesman Caravans. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 5+ years in service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
