Statesman Caravans Awning Rafter Knob
Statesman Caravans made solid gear, but the small plastics are always the first to go — and the awning rafter knob is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $22
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
Statesman Caravans made solid gear, but the small plastics are always the first to go — and the awning rafter knob is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Rafter tension knobs crack in the sun. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Statesman Caravans |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Rafter tension knobs crack in the sun |
| Typical use case | Direct replacement for the original awning rafter knob on the Statesman Caravans. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $22 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
