Trakmaster Cupboard Hinge
Trakmaster made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $24
- Estimated print time: 1–2 hours
- Minimum order: 2
- Final pricing is confirmed by quote.
Trakmaster made solid gear, but the small plastics are always the first to go — and the cupboard hinge is a regular on our bench. We've made this style of part before and can usually print yours without drama.
Why these break
Original hinges go brittle and snap at the knuckle. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Trakmaster |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Original hinges go brittle and snap at the knuckle |
| Typical use case | Direct replacement for the original cupboard hinge on the Trakmaster. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 4–6 years of regular use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
