Trakmaster Entry Grab Handle
Spares support for older Trakmaster products is patchy at best. Reproducing the entry grab handle locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $40
- Estimated print time: 2–3 hours
- Final pricing is confirmed by quote.
Spares support for older Trakmaster products is patchy at best. Reproducing the entry grab handle locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Entry handles crack at the screw bosses. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Trakmaster |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Entry handles crack at the screw bosses |
| Typical use case | Direct replacement for the original entry grab handle on the Trakmaster. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PA-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
