Kedron Table Leg Foot Cap

Salt, sun and vibration are brutal on Kedron plastics, and the table leg foot cap usually gives up first. A tougher printed replacement breaks that cycle. We've made this style of part before and can usually print yours without drama.

Why these break

Foot caps split and scratch the floor. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.

How we reproduce them

Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.

We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.

Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.