Olympic Wardrobe Door Roller
Olympic made solid gear, but the small plastics are always the first to go — and the wardrobe door roller is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Olympic made solid gear, but the small plastics are always the first to go — and the wardrobe door roller is a regular on our bench. With your sample on the bench this is a realistic reproduction job.
Why these break
Sliding door rollers flatten and doors jam. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Olympic |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Sliding door rollers flatten and doors jam |
| Typical use case | Direct replacement for the original wardrobe door roller on the Olympic. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 5+ years in service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
