Ilve Dishwasher Cutlery Basket Handle
We keep getting asked about this one — the dishwasher cutlery basket handle is one of those Ilve parts that fails long before the rest of the unit is done. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
We keep getting asked about this one — the dishwasher cutlery basket handle is one of those Ilve parts that fails long before the rest of the unit is done. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Handle hinge lugs snap off. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Ilve |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Handle hinge lugs snap off |
| Typical use case | Direct replacement for the original dishwasher cutlery basket handle on the Ilve. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $30 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
