Bostitch Tool Belt Clip
Spares support for older Bostitch products is patchy at best. Reproducing the tool belt clip locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Spares support for older Bostitch products is patchy at best. Reproducing the tool belt clip locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Belt clip snaps at the screw boss. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Bostitch |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Belt clip snaps at the screw boss |
| Typical use case | Direct replacement for the original tool belt clip on the Bostitch. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years in hard service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
