Bostitch Case Latch
Spares support for older Bostitch products is patchy at best. Reproducing the case latch locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Spares support for older Bostitch products is patchy at best. Reproducing the case latch locally is often quicker and cheaper than the hunt for old stock. With your sample on the bench this is a realistic reproduction job.
Why these break
Case latches crack in the cold or under a boot. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in PA-CF. Carbon-fibre nylon is the strongest material we run — it goes into parts that carry real load, where a lesser plastic would be the next thing to break.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Bostitch |
|---|---|
| Vehicle / equipment type | Power tool |
| Common failure mode | Case latches crack in the cold or under a boot |
| Typical use case | Direct replacement for the original case latch on the Bostitch. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PA-CF |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $12 – $28 |
| Expected lifespan | 5+ years under load |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
