EGO Mower Wheel Hub Cap
Salt, sun and vibration are brutal on EGO plastics, and the mower wheel hub cap usually gives up first. A tougher printed replacement breaks that cycle. We've made this style of part before and can usually print yours without drama.
Salt, sun and vibration are brutal on EGO plastics, and the mower wheel hub cap usually gives up first. A tougher printed replacement breaks that cycle. We've made this style of part before and can usually print yours without drama.
Why these break
Hub caps crack and wheels loosen on the axle. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | EGO |
|---|---|
| Vehicle / equipment type | Lawn mower |
| Common failure mode | Hub caps crack and wheels loosen on the axle |
| Typical use case | Direct replacement for the original mower wheel hub cap on the EGO. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
