Holden Commodore VR–VS Parcel Shelf Clip
The Holden Commodore VR–VS is a vehicle worth keeping right, and a broken parcel shelf clip shouldn't be the thing that lets it down. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $5 – $12
- Estimated print time: 20–40 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
The Holden Commodore VR–VS is a vehicle worth keeping right, and a broken parcel shelf clip shouldn't be the thing that lets it down. We've made this style of part before and can usually print yours without drama.
Why these break
Shelf support clips snap and the shelf drops. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Commodore VR–VS |
| Year range | 1993–1997 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Shelf support clips snap and the shelf drops |
| Typical use case | Direct replacement for the original parcel shelf clip on the Holden Commodore VR–VS. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 20–40 minutes |
| Estimated cost range | $5 – $12 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
