Mitsubishi Express Van Headlight Tab Repair
Wreckers are drying up for the Mitsubishi Express Van, and when they do have one, its headlight tab repair is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $40 – $90
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Wreckers are drying up for the Mitsubishi Express Van, and when they do have one, its headlight tab repair is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Why these break
Headlight mounting tabs snap in minor bumps. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
Complex geometry means we treat this as a small engineering project — scan, model, test print, refine. We'll quote before any work starts so there are no surprises.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Express Van |
| Year range | 1980–2013 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Headlight mounting tabs snap in minor bumps |
| Typical use case | Direct replacement for the original headlight tab repair on the Mitsubishi Express Van. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Hard |
| Estimated print time | 2–4 hours |
| Estimated cost range | $40 – $90 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
