Volkswagen Transporter T4–T5 Cup Holder Insert
This is the kind of cup holder insert that dealers only sell as part of a whole assembly — if they can supply it at all for a Volkswagen Transporter T4–T5 these days. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $42
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
This is the kind of cup holder insert that dealers only sell as part of a whole assembly — if they can supply it at all for a Volkswagen Transporter T4–T5 these days. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Divider flaps and spring arms snap off. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Volkswagen |
|---|---|
| Model | Transporter T4–T5 |
| Year range | 1993–2015 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Divider flaps and spring arms snap off |
| Typical use case | Direct replacement for the original cup holder insert on the Volkswagen Transporter T4–T5. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
