Mitsubishi Sigma Boot Latch Cover
This is the kind of boot latch cover that dealers only sell as part of a whole assembly — if they can supply it at all for a Mitsubishi Sigma these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $24
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
This is the kind of boot latch cover that dealers only sell as part of a whole assembly — if they can supply it at all for a Mitsubishi Sigma these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Latch trim cover cracks around its clips. UV exposure breaks down the polymer chains in the original material. By the time the surface looks chalky or faded, the strength underneath is already gone.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Sigma |
| Year range | 1977–1987 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Latch trim cover cracks around its clips |
| Typical use case | Direct replacement for the original boot latch cover on the Mitsubishi Sigma. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
