Toyota Hilux N80 Air Vent Blade Repair
The Toyota Hilux N80 is a vehicle worth keeping right, and a broken air vent blade repair shouldn't be the thing that lets it down. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $30 – $70
- Estimated print time: 2–5 hours
- Final pricing is confirmed by quote.
The Toyota Hilux N80 is a vehicle worth keeping right, and a broken air vent blade repair shouldn't be the thing that lets it down. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Vent blades snap off their pivots and rattle in the dash. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Complex geometry means we treat this as a small engineering project — scan, model, test print, refine. We'll quote before any work starts so there are no surprises.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | Hilux N80 |
| Year range | 2015–2023 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Vent blades snap off their pivots and rattle in the dash |
| Typical use case | Direct replacement for the original air vent blade repair on the Toyota Hilux N80. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Hard |
| Estimated print time | 2–5 hours |
| Estimated cost range | $30 – $70 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
