Nissan Silvia S13–S15 Door Trim Clip
We see a steady stream of Nissan Silvia S13–S15 owners chasing this exact part — the door trim clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $12
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
We see a steady stream of Nissan Silvia S13–S15 owners chasing this exact part — the door trim clip is a known weak point once the plastic has a decade of heat cycles in it. With your sample on the bench this is a realistic reproduction job.
Why these break
Clips snap when the door card is removed. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Nissan |
|---|---|
| Model | Silvia S13–S15 |
| Year range | 1988–2002 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Clips snap when the door card is removed |
| Typical use case | Direct replacement for the original door trim clip on the Nissan Silvia S13–S15. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $12 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
