Kia Stinger Door Trim Clip
Wreckers are drying up for the Kia Stinger, and when they do have one, its door trim clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $12
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
Wreckers are drying up for the Kia Stinger, and when they do have one, its door trim clip is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Why these break
Clips snap when the door card is removed. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Kia |
|---|---|
| Model | Stinger |
| Year range | 2017–2023 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Clips snap when the door card is removed |
| Typical use case | Direct replacement for the original door trim clip on the Kia Stinger. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $12 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
