Nissan Skyline R31–R34 Sun Visor Clip
Wreckers are drying up for the Nissan Skyline R31–R34, and when they do have one, its sun visor clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $8 – $18
- Estimated print time: 30–60 minutes
- Minimum order: 1
- Final pricing is confirmed by quote.
Wreckers are drying up for the Nissan Skyline R31–R34, and when they do have one, its sun visor clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Why these break
Visor clip snaps in the heat and the visor hangs down. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Nissan |
|---|---|
| Model | Skyline R31–R34 |
| Year range | 1986–2002 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Visor clip snaps in the heat and the visor hangs down |
| Typical use case | Direct replacement for the original sun visor clip on the Nissan Skyline R31–R34. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
