Stock Trough Float Valve Arm
Float valve arms for stock water troughs. Printed oversize at the stress point; we match the valve thread or bore.
Float valve arms for stock water troughs. Printed oversize at the stress point; we match the valve thread or bore.
Common failure: Float arm snaps at the valve end.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we’ll let you know what’s realistic before any work starts.
Part details
| Vehicle / equipment type | Common trough valves |
|---|---|
| Common failure mode | Float arm snaps at the valve end |
| Typical use case | Replacement part for common trough valves. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $18 – $40 |
| Expected lifespan | 2–4 years |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
