Holden Frontera Cup Holder Insert
Wreckers are drying up for the Holden Frontera, and when they do have one, its cup holder insert is usually just as brittle as yours. Printing a fresh one solves that. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $42
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Wreckers are drying up for the Holden Frontera, and when they do have one, its cup holder insert is usually just as brittle as yours. Printing a fresh one solves that. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Divider flaps and spring arms snap off. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
Bring in the broken part and we'll reverse engineer it — usually with a design tweak that addresses why it failed in the first place, not just a copy of the weak original.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Frontera |
| Year range | 1995–2003 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Divider flaps and spring arms snap off |
| Typical use case | Direct replacement for the original cup holder insert on the Holden Frontera. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
