Toyota HiAce H200 Boot Trim Clip
A boot trim clip for the Toyota HiAce H200 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
A boot trim clip for the Toyota HiAce H200 is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Why these break
Boot and tailgate trim clips crack with age. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | HiAce H200 |
| Year range | 2004–2019 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Boot and tailgate trim clips crack with age |
| Typical use case | Direct replacement for the original boot trim clip on the Toyota HiAce H200. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
