Holden Torana LC–LX Wheel Arch Liner Clip
A wheel arch liner clip for the Holden Torana LC–LX is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $3 – $8
- Estimated print time: 10–20 minutes
- Minimum order: 10
- Final pricing is confirmed by quote.
A wheel arch liner clip for the Holden Torana LC–LX is a typical small-but-annoying part: cheap when it was on a shelf, unobtainable or overpriced now. With your sample on the bench this is a realistic reproduction job.
Why these break
Liner clips break during tyre changes and scrapes. Vibration fatigue does the damage: thousands of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in Nylon. Nylon is slippery and fatigue-resistant, which makes it the right choice for parts that pivot, slide or flex thousands of times.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Torana LC–LX |
| Year range | 1969–1978 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Liner clips break during tyre changes and scrapes |
| Typical use case | Direct replacement for the original wheel arch liner clip on the Holden Torana LC–LX. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | Nylon |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 10–20 minutes |
| Estimated cost range | $3 – $8 |
| Expected lifespan | 5+ years, even on moving parts |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
