Subaru WRX Door Handle Bezel
This is the kind of door handle bezel that dealers only sell as part of a whole assembly — if they can supply it at all for a Subaru WRX these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $15 – $35
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
This is the kind of door handle bezel that dealers only sell as part of a whole assembly — if they can supply it at all for a Subaru WRX these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Bezel tabs crack when the handle surround is prised off. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Subaru |
|---|---|
| Model | WRX |
| Year range | 1994–2020 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Bezel tabs crack when the handle surround is prised off |
| Typical use case | Direct replacement for the original door handle bezel on the Subaru WRX. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
