Mitsubishi Express Van Washer Jet Clip
Wreckers are drying up for the Mitsubishi Express Van, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $15
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
Wreckers are drying up for the Mitsubishi Express Van, and when they do have one, its washer jet clip is usually just as brittle as yours. Printing a fresh one solves that. We've made this style of part before and can usually print yours without drama.
Why these break
Washer jet clips crack from engine bay heat and UV. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Mitsubishi |
|---|---|
| Model | Express Van |
| Year range | 1980–2013 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Washer jet clips crack from engine bay heat and UV |
| Typical use case | Direct replacement for the original washer jet clip on the Mitsubishi Express Van. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $15 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
