Specialized Mudguard Clip
A broken mudguard clip shouldn't sideline otherwise good Specialized equipment, and with a decent sample to work from it usually doesn't have to. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $6 – $14
- Estimated print time: 30–60 minutes
- Minimum order: 2
- Final pricing is confirmed by quote.
A broken mudguard clip shouldn't sideline otherwise good Specialized equipment, and with a decent sample to work from it usually doesn't have to. We've made this style of part before and can usually print yours without drama.
Why these break
Mudguard stays and clips snap at the bridge. The factory part is made from plastic that loses its plasticisers over the years. It gets glassy, then one day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Specialized |
|---|---|
| Vehicle / equipment type | Bicycle |
| Common failure mode | Mudguard stays and clips snap at the bridge |
| Typical use case | Replacement part for bicycle. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $6 – $14 |
| Expected lifespan | 3–5 years in full sun, longer under cover |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
