Malvern Star Kickstand Foot
Spares support for older Malvern Star products is patchy at best. Reproducing the kickstand foot locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $5 – $12
- Estimated print time: 20–40 minutes
- Final pricing is confirmed by quote.
Spares support for older Malvern Star products is patchy at best. Reproducing the kickstand foot locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Kickstand feet wear through and slip. The factory part is made from plastic that loses its plasticisers over the years. It gets glassy, then one day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in TPU. TPU is flexible and grippy, so it absorbs the impacts and vibration that crack rigid plastics, and it is kind to the surfaces it touches.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Malvern Star |
|---|---|
| Vehicle / equipment type | Bicycle |
| Common failure mode | Kickstand feet wear through and slip |
| Typical use case | Replacement part for bicycle. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | TPU |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 20–40 minutes |
| Estimated cost range | $5 – $12 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
