Cable Management Clip Pack
The cable management clip pack is one of those parts that retires perfectly good gear. Printing a replacement is usually quick and cheap. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $0.50 – $2 each
- Estimated print time: 5–10 minutes each
- Minimum order: 10
- Final pricing is confirmed by quote.
The cable management clip pack is one of those parts that retires perfectly good gear. Printing a replacement is usually quick and cheap. We've made this style of part before and can usually print yours without drama.
Why these break
Adhesive clips let go and cables spaghetti. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — years on, there's no margin left in it.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Vehicle / equipment type | Desk / AV setups |
|---|---|
| Common failure mode | Adhesive clips let go and cables spaghetti |
| Typical use case | Replacement part for desk / AV setups. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | TPU |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 5–10 minutes each |
| Estimated cost range | $0.50 – $2 each |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
