New Holland Gauge Bezel
If the gauge bezel on your New Holland has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $14 – $30
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
If the gauge bezel on your New Holland has cracked or crumbled, it's a part we can usually sort without chasing discontinued spares. With your sample on the bench this is a realistic reproduction job.
Why these break
Dash gauge bezels crack and fog lets dust in. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — years on, there's no margin left in it.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | New Holland |
|---|---|
| Vehicle / equipment type | Tractor / farm machinery |
| Common failure mode | Dash gauge bezels crack and fog lets dust in |
| Typical use case | Replacement part for tractor / farm machinery. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $14 – $30 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
