Ford Falcon AU Door Trim Clip
If the door trim clip on your Ford Falcon AU has let go, you're in good company — it's one of the plastics on these that simply doesn't age well. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $12
- Estimated print time: 15–30 minutes
- Minimum order: 4
- Final pricing is confirmed by quote.
If the door trim clip on your Ford Falcon AU has let go, you're in good company — it's one of the plastics on these that simply doesn't age well. We've made this style of part before and can usually print yours without drama.
Why these break
Clips snap when the door card is removed. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
As with everything in our library: whether a part can be reproduced depends on size, load, heat, material, and having a decent sample to work from. Send photos first — the assessment costs you nothing, and we'll tell you honestly if a genuine spare is the better option.
Part details
| Manufacturer | Ford |
|---|---|
| Model | Falcon AU |
| Year range | 1998–2002 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Clips snap when the door card is removed |
| Typical use case | Direct replacement for the original door trim clip on the Ford Falcon AU. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Alternative materials | ABS |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $12 |
| Expected lifespan | 3–5 years in normal use |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
