Holden Commodore VF Sun Visor Clip
The Holden Commodore VF is a car worth keeping right, and a broken sun visor clip shouldn't be the thing that lets the interior down. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $8 – $18
- Estimated print time: 30–60 minutes
- Minimum order: 1
- Final pricing is confirmed by quote.
The Holden Commodore VF is a car worth keeping right, and a broken sun visor clip shouldn't be the thing that lets the interior down. We've made this style of part before and can usually print yours without drama.
Why these break
Visor clip snaps in the heat and the visor hangs down. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
Reproducing one is straightforward for us: we measure your sample (broken is fine, as long as most of it is there), match the profile, and print in a tougher modern material. Turnaround is usually within the week.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Commodore VF |
| Year range | 2013–2017 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Visor clip snaps in the heat and the visor hangs down |
| Typical use case | Direct replacement for the original sun visor clip on the Holden Commodore VF. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 30–60 minutes |
| Estimated cost range | $8 – $18 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
