Holden Commodore VF Glovebox Hinge Repair
This is the kind of glovebox hinge repair that dealers only sell as part of a whole assembly — if they can supply it at all for a Holden Commodore VF these days. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $25 – $55
- Estimated print time: 2–3 hours
- Final pricing is confirmed by quote.
This is the kind of glovebox hinge repair that dealers only sell as part of a whole assembly — if they can supply it at all for a Holden Commodore VF these days. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Hinge lugs shear so the glovebox lid drops or falls out. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG-CF. Carbon-fibre PETG is noticeably stiffer than the stock plastic, so the part holds its shape under clamping force instead of slowly creeping loose.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Holden |
|---|---|
| Model | Commodore VF |
| Year range | 2013–2017 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Hinge lugs shear so the glovebox lid drops or falls out |
| Typical use case | Direct replacement for the original glovebox hinge repair on the Holden Commodore VF. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG-CF |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–3 hours |
| Estimated cost range | $25 – $55 |
| Expected lifespan | 4–6 years under clamping load |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
