Millard Window Latch Handle
A broken window latch handle shouldn't sideline otherwise good Millard equipment, and with a decent sample to work from it usually doesn't have to. We've made this style of part before and can usually print yours without drama.
A broken window latch handle shouldn't sideline otherwise good Millard equipment, and with a decent sample to work from it usually doesn't have to. We've made this style of part before and can usually print yours without drama.
Why these break
Handle snaps at the pivot from UV embrittlement. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Millard |
|---|---|
| Vehicle / equipment type | Caravan / pop-top |
| Common failure mode | Handle snaps at the pivot from UV embrittlement |
| Typical use case | Direct replacement for the original window latch handle on the Millard. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG-CF |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $15 – $35 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
