Westinghouse Fridge Crisper Rail End
Westinghouse made solid gear, but the small plastics are always the first to go — and the fridge crisper rail end is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $20 – $50
- Estimated print time: 1–3 hours
- Final pricing is confirmed by quote.
Westinghouse made solid gear, but the small plastics are always the first to go — and the fridge crisper rail end is a regular on our bench. Variants differ between years and models, so we'll need your part (broken is fine) to match the exact one.
Why these break
Rail ends crack so the crisper sags or jams. Vibration fatigue does the damage: thousands of kilometres of small flexes add up to a crack at the stress point, usually right where the part clips or pivots.
How we reproduce them
These take a proper modelling pass: we measure the mounting points and clip geometry from your part, reinforce the known failure point, and verify fit with a test print before the final run.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Westinghouse |
|---|---|
| Vehicle / equipment type | Household appliance |
| Common failure mode | Rail ends crack so the crisper sags or jams |
| Typical use case | Direct replacement for the original fridge crisper rail end on the Westinghouse. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–3 hours |
| Estimated cost range | $20 – $50 |
| Expected lifespan | 5+ years indoors |
| Outdoor suitable | No |
| Heat resistant | Depends |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
