Hyundai iLoad Cup Holder Insert
Wreckers are drying up for the Hyundai iLoad, and when they do have one, its cup holder insert is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $18 – $42
- Estimated print time: 2–4 hours
- Final pricing is confirmed by quote.
Wreckers are drying up for the Hyundai iLoad, and when they do have one, its cup holder insert is usually just as brittle as yours. Printing a fresh one solves that. With your sample on the bench this is a realistic reproduction job.
Why these break
Divider flaps and spring arms snap off. The original was moulded thin to save cents at production volume. That was fine when the plastic was fresh — twenty years on, there's no margin left in it.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in PETG. PETG has a little give in it, so it snaps into place like the original and shrugs off the knocks that shattered the old part.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Hyundai |
|---|---|
| Model | iLoad |
| Year range | 2008–2021 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Divider flaps and spring arms snap off |
| Typical use case | Direct replacement for the original cup holder insert on the Hyundai iLoad. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | PETG |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 2–4 hours |
| Estimated cost range | $18 – $42 |
| Expected lifespan | 4–6 years in typical service |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
